Analysis of the difficulty of thermoforming titanium alloy rods

Dec 17, 2022

Analysis of the difficulty of thermoforming titanium alloy rods


The deviation of the geometric accuracy of titanium alloy rods is mainly caused by the elasticity of the material.Titanium alloy rods are thermoformed, with poor internal and lower plasticity, high deformation resistance, and serious rebound, so the forming problem is difficult and the geometric accuracy is low.


The thermoforming of titanium alloy rods, due to the soft ratio of high temperature to the material, greatly reduces the distortion and rebound of the parts after forming, but the rebound cannot be completely eliminated.For example, the resistance heating and pressing of titanium alloy rods is formed or the stroke is formed.Some parts still have a small amount of rebound after thermoforming, and the geometric accuracy does not meet the quality requirements, so heavy manual trimming must be carried out.


TC4 titanium alloy has a series of advantages such as excellent corrosion resistance, small density, high specific strength, good toughness and weldability, and has been successfully used in aerospace, petrochemical, shipbuilding, automotive and pharmaceutical sectors.During the thermoforming process of TC4 titanium alloy, a layer of oxide skin will form on its surface. The thermoforming temperature is different, and the color of the oxide skin obtained is also different.Among them, when the thermoforming temperature is about 600℃, the oxide skin is blue; when the thermoforming temperature is about 850℃, the oxide skin is gray and reddish; and when the thermoforming temperature is 900℃, the oxide skin is gray.As the temperature rises, the difficulty of removing the oxide skin gradually increases.Most of the removal of titanium alloy oxide skins at home and abroad adopts a two-step method, that is, first melting alkali washing, and then pickling; however, the temperature of the molten alkali washing medium is higher, which can reach about 450℃, and it is easy to cause premature aging of α+β and β titanium alloy semi-finished products, which brings difficulties to further processing.In addition, hot alkali washing and then cleaning with nitric acid and hydrofluoric acid may also cause hydrogen embrittlement corrosion on the surface of titanium alloys.